NINJA250 NINJA400 Aluminum Separate Handle Kit SNIPER
【outlet goods】
The handle clamp part is already installed on the exhibition vehicle, but there are installation marks on the bolt part.
Handlebars are unused
Compatible models
NINJA250 EX250P (18~)
NINJA400 EX400G (18~)
25mm lower than the original
Offset 20mm forward from stock
Fork bracket thickness 28mm
Handlebar outer diameter Φ22.2mm, length 230mm
Handle inner diameter 16mm
Handle hanging angle steplessly adjustable
Handle opening angle steplessly adjustable
Regarding installation
Please be sure to request installation by a qualified and experienced person such as a mechanic.
The handlebar is screwed into the handle bracket.
Please use thread locking agent to prevent the handlebar from loosening before installation.
There is no hole for the switch housing on the handlebar, so drilling is required.
Please install the front fork with a protrusion of 6mm.
Please be careful about the routing and cutting angle of the brake hose.
Here, in order to give more room for routing the brake hose after installation.
The brake hose is routed outside the top bridge clamp.
Please install with care to avoid interference with tanks and cowls.
