SNIPER Sniper motorcycle custom parts

Products purchased together

NINJA ZX-25R ZX-4R Aluminum Separate Handlebar Kit

SP0078K

20,900yen

List price 20,900 yen (tax included)

NINJA ZX-25R ZX-4R Aluminum Separate Handlebar Kit SNIPER Sniper SP0078K
4589993472712

Compatible models
NINJA ZX-4R SE (23-)
NINJA ZX-4R (23-)
NINJA ZX-25R SE (23-)  
NINJA ZX-25R SE (20-22)  
NINJA ZX-25R (20-)

Customized vehicle of "Ninja ZX-25R" published on Kawasaki Indonesia's official YouTube
Pre-installed on Kawasaki Thailand's "Ninja ZX-25R" custom exhibition vehicle

This is a racing handle for A-TEC carbon cowl.
As this is a race-specific product, drilling is required to install the handlebar switches.

Same height as original
Offset 20mm forward from stock
Fork bracket thickness 28mm
Handlebar outer diameter Φ22.2mm, length 282mm/effective length 227mm
Height: 45mm from the top of the bracket to the top of the handle
Height: 35mm from top of bracket to center of handle
Handle inner diameter 16mm
Handle hanging angle steplessly adjustable
Handle opening angle steplessly adjustable
Handle weight: 845g (original handle is 1552g)

It can also be installed on the genuine cowl, but there are limits to the installation range.
Adjust the hanging angle and opening angle, being careful not to interfere with the cowl or tank.

For reference, according to our research, if it is also attached to the genuine cowl
The hanging angle is 10 degrees, and the opening angle is narrower than the original handle, so there is no interference.
It is offset 20mm further forward than the original, but the opening angle is narrowed down so it doesn't feel far away.

The master cylinder guard sold separately cannot be installed at the same time as it interferes with the genuine cowl.
Please be careful not to interfere with the genuine cowl when replacing with an aftermarket lever.

Regarding installation
Please be sure to request installation by a qualified and experienced person such as a mechanic.
As this is a race-specific item, drilling is required to install the handlebar switches.
Please pay attention to the routing and cutting angle of the brake hose when installing.
If the brake hose is strained, the brake hose needs to be replaced.
Please be careful of interference with tanks and cowls.

Products purchased together